DURO Purlins and Girts are precise roll-formed from high tensile zinc-galvanised steel. DURO Purlins and Girts are precise roll-formed from high tensile zinc-galvanised steel.
 

They are designed for use as secondary supports for a wide range of roofing and wall cladding materials. DURO Purlins and Girts are precise roll-formed from high tensile zinc-galvanised steel.

PRODUCTS BENEFITS

• Permanent Formwork

• Tensile reinforcement in lieu of positive reinforcement

• Composite construction with composite beam design to reduce steel frame weight

• Lower dead load that reduces frame and foundation loading

• Fire resistance with exposed soffit for up to two hours

• Quick and easy construction with no specialized skills needed

• Safe working platform

• Minimal propping requirements

• High structural efficiency due to high strength steel

• Stiffens supporting frame in tall steel buildings

• Design Flexibility

• On-site shear studs welding through-deck for composite action

• Can be used on steelwork, concrete, blockwork, and masonry structures

• Installation of suspended ceiling and service fittings

APPLICATIONS

• Suitable for most ceiling finishes including painting and plaster

AVAILABLE LENGTHS
DURODEK™ profiled sheeting are cut at standard lengths from 600mm up to 12000mm. Custom-cut lengths greater than 12000mm are also available but special freight and handling facilities will be requited. Where handling weights permit, DURODEK™ should be used in lengths that cover multiple spans.

CORROSION PROTECTION
For durability and resistance, DURODEK™ profiled steel sheeting is packaged in strapped bundles that should be stacked neatly off the ground at a slight slope to allow

MATERIAL SPECIFICATIONS

*Notes: For 1.2mm, ASTM A446 Grade D, minimum 350 Mpa